Secvest Wireless Alarm System
What happens after a signal fault?
What happens after a signal interruption or fault ? Does the system switch back to normal operation afterwards?
What happens after a signal interruption or fault ? Does the system switch back to normal operation afterwards?
The Abus Secvest wireless alarm system is designed to attempt to restore the signal in the event of a signal interruption or malfunction. Once the malfunction has been rectified, the system normally switches back to normal operation.
The exact procedure depends on the type of signal interference. For example, if the radio signal between a sensor and the control panel is interrupted, the system may attempt to restore the signal by retransmitting the signal. If this is not possible because the interference continues or the sensor is damaged, the system may display an error code or trigger an alarm.
In any case, it is important that you check your Abus Secvest wireless alarm system in the event of a signal fault or interruption and possibly identify and rectify the cause of the fault.
You know a better answer?
The question about Abus Secvest Wireless Alarm System has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Display mirrored ?
<1Kviews
my display is mirrored how does that go back with the Secvest Touch.thank you
Can the sensors and actuators all be integrated wirelessly?
1.6Kviews
What if I rent an apartment, which means I can't put wires under the plaster? Does that mean I can't have an alarm?
What is so special about ABUS Mechatronik?
1.4Kviews
Why are mechatronic products an innovation in alarm technology?
Was the content helpful to you?