Theater Mode addition together with fixes to Airplay and SNMP issues
Improvement(s)
? Theater Mode: Grab the attention with your content and nothing else. Get your content in the picture, full size and full screen.
? Time at on the wallpaper can be set to a 12hr or 24hr time at: This will be applied to the clock shown in the status bar and in the room availability section on the wallpaper.
✔ ️ Performance enhancements when integrating the Buttons into the corporate network: With the feedback received on the 2.8 firmware release, we have been able to identify some areas of improvement and these improvements can be found in this firmware.
? Miracast available in more configurations. Thanks to the addition of Miracast MS-MICE capabilities (aka Miracast Over Infrastructure), Miracast can be used on all CX and C models in additional configurations.
? Media streaming over Airplay: This firmware adds support to stream media content from YouTube and other applications to your ClickShare device.
Resolved Issue(s)
✔ ️ BYOD Airplay does not work when streaming Youtube movies.
✔ ️ SNMP not working in wireless client mode.
Known Issue(s)
? Button Manager currently does not work with the ClickShare Present Buttons.
? First-time setup wizard can stay a few minutes on the 'checking for updates' and 'registration' page (in specific network configurations). Occasionally (e.g. time-out), an error page can pop-up to highlight the networking difficulties, however the onboarding wizard will continue automatically once the confirmation is passed-through.
? SmartCare info might not reflect the actual state in specific cases following unclaiming the device: KB11513.
? When using Airplay with Youtube, disconnecting and reconnecting is needed in case an error message pops up over the streaming content
Note(s)
? It is highly recommended to always use a free 5GHz Wi-Fi channel to optimize the performance of Wireless Presentation. These settings can be changed via the ClickShare Configurator.