Update

Adds Theater Mode, dynamic camera quality along with other improvements

Improvement(s)

? Theater Mode: Grab the attention with your content and nothing else. Get your content in the picture, full size and full screen.

? Dynamic camera quality to ensure smooth video: In challenging environments, the camera quality will gracefully be degraded to ensure a smooth and low latency camera stream and a great overall experience.

? Support for additional peripherals and true 720p for more peripherals: With every release, we aim to support more and more conference peripherals and improve the overall quality of the system. Thanks to the 'True 720p' enhancements, several popular peripherals will see a significant improvement in camera quality.

? Time at on the wallpaper can be set to a 12hr or 24hr time at: This will be applied to the clock shown in the status bar and in the room availability section on the wallpaper.

✔ ️Performance enhancements when integrating the Buttons into the corporate network: With the feedback received on the 2.8 firmware release, we have been able to identify some areas of improvement and these improvements can be found in this firmware.

✔ ️Miracast available in more configurations. Thanks to the addition of Miracast MS-MICE capabilities (aka Miracast Over Infrastructure), Miracast can be used on all CX and C models in additional configurations.

? Media streaming over Airplay: This firmware adds support to stream media content from YouTube and other applications to your ClickShare device.

Resolved Issue(s)

✔ ️Vaddio EasyUSB Mixer/Amp and TableMIC not working on USB-A ports.

✔ ️BYOD Airplay does not work when streaming Youtube movies.

✔ ️SNMP not working in wireless client mode.

Known Issue(s)

? Button Manager currently does not work with the ClickShare Conference Buttons.

? Adding device into XMS cloud can give a "unable to add device" error. Make sure the Base Unit is updated to FW 2.5 and reset to factory defaults to try again.

? First-time setup wizard can stay a few minutes on the 'checking for updates' and 'registration' page (in specific network configurations). Occasionally (e.g. time-out), an error page can pop-up to highlight the networking difficulties, however the onboarding wizard will continue automatically once the confirmation is passed-through.

? SmartCare info might not reflect the actual state in specific cases following unclaiming the device: KB11513.

? When using Airplay with Youtube, disconnecting and reconnecting is needed in case an error message pops up over the streaming content.

? Unable to share with the ClickShare (conference) Button when Logi Sync software is installed on the PC: KB11514.

? Rapidly pressing the mute button on the Jabra Speak devices can lead to the peripheral being out-of-sync with MS Teams.

? Conferencing controls, including mute, are not working with specific Jabra Speak 510 versions.

? Certain peripherals do not always wake-up after both the peripheral and the ClickShare Conference Base Unit were in stand-by.

Note(s)

? It is highly recommended to always use a free 5GHz Wi-Fi channel to optimize the performance of Wireless Conferencing. These settings can be changed via the ClickShare Configurator.

? Wireless client mode is supported however for Wireless Conferencing, a direct connection between the Button and the Base Unit is advised.

Version: 2.9.0.3 Link
Receive Important Update Messages Stay tuned for upcoming Barco ClickShare CX-30 updates
The manufacturer Barco has set up its devicebase profile. Contents like updates, compatibilities and support are maintained regularly.

Was the content helpful to you?

Advertisement Advertise here?
Banner exertis ProAV