Enabled a GPIO logic input connection and fixed line-level audio

New Firmware Features

• Added fixed line-level audio Assistive Listening Output in Launched FORTE X systems.

• Enabled a GPIO logic input connection to support a fire alarm mute in Launched TesiraFORTE X systems.

Firmware Updates

• Updated minimum version requirement for TesiraFORTÈ AVB and TesiraFORTÈ DAN for Rev. C. All TesiraFORTÈs Rev. C must use Tesira Firmware 4.4.3 or later. All previous versions of TesiraFORTÈ are supported in this firmware version.

• TesiraFORTE X will now pulse the Launch ready light when a firmware update has added new features which would require a re-launch to use. The Launch website will also reflect that Launch must be rerun.

Bug Fixes

• Resolved issue with EX-UBT not enumerating on some PCs after a rebooted.

• Resolved issue with malformed IGMP membership reports from TC-5/D

• Resolved issue where a Tesira device could lose communication with a Parlè mic after a firmware update.

• Resolved issue where the logic out for mute status on a USB block could become out of sync when performing a preset recall on a TesiraFORTÈ X.

• Resolved issue with TC-5 and TC-5D not switching to no-querier mode after losing IGMP querier election.

• Resolved an issue when a TEC-X block is placed on a video partition could cause a LUX to require a power cycle after resending a layout.

• Resolved issue when using TesiraFORTÈ X’s with rack mount TesiraFORTÈs and TEC-X blocks could result in the system halting when sending a new layout.

• Resolved issue when a NPX-1 Paging stations would reconfigure on a layout send even if the configuration of the Paging station did not change.