Set ATEM Mini Extreme to factory settings?

Hello, here are detailed step-by-step instructions.

Switch off the device:

• Completely disconnect the power cable of the ATEM Mini Extreme to unplug it from the mains.

Press and hold button:

• Press and hold the top left button (the "ON"button) on the device. This is the top left button on the control panel.

Switch on the device:

Plug the power cable back in while continuing to hold down the button. The device will now start in reset mode.

Wait for confirmation:

• The LEDs on the device start to flash. As soon as the flashing pattern appears, you can release the button. The reset process now runs automatically (takes approx. 1-2 minutes).

Establish connection:

• Connect the ATEM Mini Extreme to your computer via USB or Ethernet. Open the ATEM Software Control on the computer - the device should now be recognized as "Recovery Mode" or similar.

Reinstall firmware (recommended):

• Download the latest ATEM software and firmware from the Blackmagic website.
• Follow the instructions in the software to flash the firmware. This will ensure the device is up to date and the reset will take full effect.

Completion:

• After rebooting, the device will display the welcome screen or standard mode. Reconfigure it via the ATEM software.