Blackmagic DesignATEM Mini Pro ISO
<1K views
Reset factory settings?
How can I restore the factory settings on my ATEM Mini Pro ISO?
Blackmagic DesignATEM Mini Pro ISO
Answers
Hello, here are detailed step-by-step instructions.
Switch off the device:
- Completely disconnect the power cable of the ATEM Mini Pro ISO to unplug it from the mains.
Press and hold button:
- Press and hold the top left button (the "ON"button) on the device. This is the top left button on the control panel.
Switch on the device:
Plug the power cable back in while continuing to hold down the button. The device will now start in reset mode.
Wait for confirmation:
- The LEDs on the device start to flash. As soon as the flashing pattern appears, you can release the button. The reset process now runs automatically (takes approx. 1-2 minutes).
Establish connection:
- Connect the ATEM Mini Pro ISO to your computer via USB or Ethernet. Open the ATEM Software Control on the computer - the device should now be recognized as "Recovery Mode" or similar.
Reinstall firmware (recommended):
- Download the latest ATEM software and firmware from the Blackmagic website.
- Follow the instructions in the software to flash the firmware. This will ensure the device is up to date and the reset will take full effect.
Completion:
- After rebooting, the device will display the welcome screen or standard mode. Reconfigure it via the ATEM software.
You know a better answer?
The question about Blackmagic Design has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Related Questions
Advanced setting ATEM Mini Pro ISO?
Hello everyone,
can someone explain to me how I can access the advanced settings and what configuration options are available there?
Thank you very much!
Stay up to date on Blackmagic Design
Was the content helpful to you?
