Blackmagic DesignATEM Mini Pro
<1K views
Reset to factory settings?
Hi, I can't find a way to reset my ATEM Mini Pro to factory settings. Can anyone help me?
Blackmagic DesignATEM Mini Pro
Answers
Hello, here are detailed step-by-step instructions.
Switch off the device:
- Completely disconnect the power cable of the ATEM Mini Pro to unplug it from the mains.
Press and hold button:
- Press and hold the top left button (the "ON"button) on the device. This is the top left button on the control panel.
Switch on the device:
Plug the power cable back in while continuing to hold down the button. The device will now start in reset mode.
Wait for confirmation:
- The LEDs on the device start flashing. As soon as the flashing pattern appears, you can release the button. The reset process now runs automatically (takes approx. 1-2 minutes).
Establish connection:
- Connect the ATEM Mini Pro to your computer via USB or Ethernet. Open the ATEM Software Control on the computer - the device should now be recognized as "Recovery Mode" or similar.
Reinstall firmware (recommended):
- Download the latest ATEM software and firmware from the Blackmagic website.
- Follow the instructions in the software to flash the firmware. This will ensure the device is up to date and the reset will take full effect.
Completion:
- After rebooting, the device will display the welcome screen or standard mode. Reconfigure it via the ATEM software.
You know a better answer?
The question about Blackmagic Design ATEM Mini Pro has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Related Questions
How do I access the ATEM Mini Pro settings?
Hello, is there a way to make settings for the ATEM Mini Pro? If so, what do I need to do this? Is there access...
Is ATEM compatible with all projectors?
I have two projectors that work perfectly with the direct image from the camera (EPSON X36+ and EPSON X24+), but when the signal passes through...
Is it possible to control it externally (via Crestron)?
Is it possible to control the Blackmagic Design ATEM Mini Proit externally via Crestron?
Stay up to date on Blackmagic Design ATEM Mini Pro
More from the Signalmanagement section
Was the content helpful to you?
