The manufacturer Bose has set up its devicebase profile. Contents like updates, compatibilities and support are maintained regularly.
Update

Added ControlSpace Accelerator

Improvements

Added ControlSpace Cloud integration for remote monitoring

  • Introduction of ControlSpace Cloud device controls in CSD
  • Updated Firmware for DSP and amplifiers to function with ControlSpace Cloud

Added ControlSpace Accelerator

  • At the same time of the release of CSD 5.14 and ControlSpace Cloud, we are also releasing ControlSpace Accelerator in standalone application or web-based versions

New Loudspeaker presets

  • EdgeMax-LP (including SmartBass presets)
  • AMU 108-120, AMU 208-120

Changes

  • PowerShareX PSX amplifiers now updated to v1.12 firmware
  • Updated EdgeMax and EdgeMax-LP device icons in project view
  • Add alarms for clip and limit for Powershare D, to allow a similar experience to other amplifiers

Defect Fixes

  • (Fixed in 5.13.2): Fixed defect where PowerShareX amplifier limiter blocks reverted to default channel limiter settings just after going online with downloading, instead of using the configuration values
  • Serial Protocol Document 5.13 now included in help folder
  • Fixed intermittent issue that could occur when updating firmware on CSD firmware on
    Under Table boxes (EX-UH, EX-4ML, EX-8ML)
  • Corrected issue where EX-ML becomes unresponsive after PSet recall via command to paired
    EX processor
  • Corrected issue where Output signal indicators of the PSX occasionally light up when there is no signal
  • Fixed issue where PSX Alarm of Short Circuit is not reflected in Fault indicators on the CSD
  • Fixed issue where Selection of the dropdown of the MSA12X Auto-Standby may keep changing
  • Fixed issue where MAC address of the Dante card is erroneously displayed in MAC Address field of Hardware Manager
  • Fixed issues with PowerMatch
  • Fixed issue where IP addresses displayed on "Set Master DSP" dialog may differ from those of the actual devices
  • Fixed issues with MSA12X
  • Fixed issue where Some changes of the PSX Array EQ by SoIP commands are not reflected in the CSD appropriately
  • Fixed issue where Matrix may be registered in a Parameter Set with an incorrect number of ports
  • Fixed issue where Wire style changes are not reflected in the Logic View
  • Fixed issue where Some wires inside a logic block disappear
  • Fixed issue, where Backup Strategy block of the PSX cannot be registered to Group
  • Fixed issue where Standby settings of amplifiers in a Parameter Set are not deleted by deleting the device
  • Fixed issue of redrawing device names in project view
  • Fixed issue of Recall button remains orange after deleting the contents of Parameter Set
Receive Important Update Messages Stay tuned for upcoming Bose EX-1280C updates

Was the content helpful to you?