Via ControlSpace Designer: Newly added support features

Improvements

• Added support for Windows 11

• Added MSA12X health and status indicators in Project View

• Added guidance in MSA12X control panel to enable endpoint control

Changes

• MSA12X IP address is now set via Dante Controller

• Reduced time to go online in designs with multiple logic routes

• Improved input labels in MSA12X control panel

Bug fixes

General issues

• Fixed issue when EX and ESP processors do not acquire a link-local address when DHCP lease expires.

• Fixed issue changing network configuration on virtual NICs.

• Fixed issue updating MSA12X firmware.

• Fixed issue when successful MSA12X firmware update incorrectly reported as failed.

• Fixed issue reconnecting to MSA12X after firmware update.

• Fixed issue right-clicking on logic routes and audio routes in the Project Directory.

• Fixed issue moving PowerMatch and PowerShare-D signal processing blocks.

• Fixed issue generating missing loudspeaker EQ presets during ControlSpace Designer startup.

Audio Processing

• Fixed issue muting a matrix mixer input or output channel.

• Fixed issue copying mute state when duplicating a matrix mixer.

• Fixed issue copying matrix mixer mute state from the context menu.

• Fixed issue renaming multiple signal processing blocks from the context menu.

• Fixed issue displaying ATS value in Gated AMM signal processing blocks with more than 16 channels.

• Fixed issue repeatedly clicking a boundary wall in the Standard Room Combiner control panel.

• Fixed issue when wires connected to Room Combine Inputs may disappear when deleting a Standard Room Combiner signal processing block.

• Fixed issue displaying the Enhanced AGC Total Gain as 60 dB without signal.

• Fixed issue displaying AEC references in Project Directory.

Control

• Fixed issue entering an incomplete Serial Out IP address.

• Fixed issue validating Serial Out IP addresses.

3rd Party Devices

• Fixed issue copying TCC2 LED color and brightness state

• Fixed issue operating TCC2 control panel while CSD is online.

• Fixed issue allowing TCC2 logic blocks to be assigned to Parameter Sets and Timers.

Logic

• Fixed issue displaying correct Serial Out logic connector state via the control panel and serial command.

Dante

• Fixed issue when Dante endpoint subscriptions may not be created when opening a project file.

• Fixed issue displaying imported Dante firmware files in Dante Updater as available for update. Resolved with Dante Updater 4.6.

• Fixed issue when disconnected Dante endpoints show partial settings in Hardware Manager.

• Fixed issue displaying Dante endpoints configured with static IP addresses in uppercase in Hardware Manager.

Open issues

Signal Processing

If a USB Input module is not wired to an Output module, that module will not show metering data.

ControlSpace Designer Logic Blocks

• Assigning a logic action from an ESP-00 to a trigger on an EX-1280 will result in an error.

• The states of logic connectors within the Logic Wiring View may sometimes show the incorrect state. This does not affect the functionality.

• If you are experiencing issues with go-online time or ControlSpace Designer crashes when going online, consider dragging and dropping logic blocks instead of copying and pasting them.

• If you are finding ControlSpace Designer crashes when going online with a large number of logic routes, try going online from Project View.

Dante Endpoints

• The EX-8ML may boot up with a link-local address upon first use rather than DHCP. Rebooting the device will then revert the address to DHCP.

Telephone Call Functionality

• PSTN and VoIP ring and voice levels are not being properly set. There is no difference in audible level between 0 dB and +10 dB.

ControlSpace Remote

• On an Avaya system, it is not possible to end a VoIP call with ControlSpace Remote when the far end is in a hold state.

Other Issues

• When programming selectors, gains, analog inputs/outputs for digital GPI, they may not function when using EX-1280C with legacy devices.

• PowerMatch will not alert the use