Added ControlSpace Accelerator
Improvements
Added ControlSpace Cloud integration for remote monitoring
- Introduction of ControlSpace Cloud device controls in CSD
- Updated Firmware for DSP and amplifiers to function with ControlSpace Cloud
Added ControlSpace Accelerator
- At the same time of the release of CSD 5.14 and ControlSpace Cloud, we are also releasing ControlSpace Accelerator in standalone application or web-based versions
New Loudspeaker presets
- EdgeMax-LP (including SmartBass presets)
- AMU 108-120, AMU 208-120
Changes
- PowerShareX PSX amplifiers now updated to v1.12 firmware
- Updated EdgeMax and EdgeMax-LP device icons in project view
- Add alarms for clip and limit for Powershare D, to allow a similar experience to other amplifiers
Defect Fixes
- (Fixed in 5.13.2): Fixed defect where PowerShareX amplifier limiter blocks reverted to default channel limiter settings just after going online with downloading, instead of using the configuration values
- Serial Protocol Document 5.13 now included in help folder
- Fixed intermittent issue that could occur when updating firmware on CSD firmware on
Under Table boxes (EX-UH, EX-4ML, EX-8ML) - Corrected issue where EX-ML becomes unresponsive after PSet recall via command to paired
EX processor - Corrected issue where Output signal indicators of the PSX occasionally light up when there is no signal
- Fixed issue where PSX Alarm of Short Circuit is not reflected in Fault indicators on the CSD
- Fixed issue where Selection of the dropdown of the MSA12X Auto-Standby may keep changing
- Fixed issue where MAC address of the Dante card is erroneously displayed in MAC Address field of Hardware Manager
- Fixed issues with PowerMatch
- Fixed issue where IP addresses displayed on "Set Master DSP" dialog may differ from those of the actual devices
- Fixed issues with MSA12X
- Fixed issue where Some changes of the PSX Array EQ by SoIP commands are not reflected in the CSD appropriately
- Fixed issue where Matrix may be registered in a Parameter Set with an incorrect number of ports
- Fixed issue where Wire style changes are not reflected in the Logic View
- Fixed issue where Some wires inside a logic block disappear
- Fixed issue, where Backup Strategy block of the PSX cannot be registered to Group
- Fixed issue where Standby settings of amplifiers in a Parameter Set are not deleted by deleting the device
- Fixed issue of redrawing device names in project view
- Fixed issue of Recall button remains orange after deleting the contents of Parameter Set