EX processors now display “–“ if Dante network mode is unknown.

Changes

• Updated device firmware:

1. EX (EX-12AEC/440C/1280/1280C)
2. ESP (ESP-880/880A/880AD/1240/1240A/1240AD/1600/4120)

• Updated Dante firmware:

1. EX-8ML (BK3): 4.1.0
2. EX-12AEC (BK3): 4.1.0
3. EX-440C (BK3): 4.1.0
4. EX-1280 (BK3): 4.1.0
5. EX-1280C (BK3): 4.1.0
6. PowerMatch (BK3): 4.1.0

• Added a new help file topic: Internet Access Requirements (ControlSpace Cloud).
• ControlSpace Serial Control Protocol updated for v5.14.1.
• EX processors do not require a full reboot after receiving a DHCP address.
• EX processors now display “–“ if Dante network mode is unknown.
• PowerShare-D parameters can no longer be associated with CC-16 or CC-64 controls.

Defect Fixes

• Resolved an issue for PowerShareX amplifiers where the “Gateway” field displays as red in “New Network Settings.
• Resolved an issue for CC-xD controllers that resulted in device labels not auto-incrementing
• when duplicated in the project view.
• Resolved an issue that caused PowerMatch firmware updates to fail.
• Resolved an issue copying and pasting parameters between MSA12X devices

Known Issues, Defects, and Limitations

PSX Amplifiers Settings in Device

• PSX cannot act as RTC/Main device
• PSX cannot allow parameter sets, CC-xD, CSR controls to dynamically control the amplifier
• when the PC is offline
• PSX cannot use timers
• PSX Power-On state is always ‘restore last settings’ and this cannot be toggled off
• All inputs wake up PSX from standby and you cannot limit it to fewer inputs

PSX Amplifiers Signal Processing

• PSX amplifier’s limiter behaves differently than PowerMatch or PowershareD, therefore custom limiter presets have been loaded in the Bose Professional Loudspeaker EQ preset files bank that comes with CSD. They contain different values than PowerMatch or PowerShareD amplifiers.

ControlSpace Cloud

• In rare cases, you may need to reboot an EX processor after configuring a DHCP address for telemetry information to be sent to the cloud server.