DesignMax Pendant Loudspeakers support and EdgeMax Preset Update

Improvements

• Support for the new DesignMax loudspeakers: Addition of Loudspeaker EQs and SmartBass support for DesignMax DM3P, DM5P, DM6PE, DM10P-SUB

• EdgeMax EQ preset update - Resolves issues with 8-ohm configuration of EdgeMax EM90, EM180: Limiter now set to correct values of 63 V Peak, 31.5 V RMS.

Open issues

General Issues

• The SpeakerEQ graph (under Configuration  Outputs) will not display BW36/BW48 for pre-defined speakers but these filters are being applied to the audio.

• Backtracking in Quick Setup Wizard Output configuration can cause channels to not show up as assignable. Workaround is to exit and restart the Quick Setup Wizard.

• The initial DynamicEQ calibration level can be much louder than expected (0 dB). It is recommended that users manually enter -32 dB into the initial calibration screen prior to making adjustments. Alternatively, the user can simply refresh their browser immediately prior to calibrating Dynamic EQ.

• The Dashboard View does not currently automatically refresh to reflect changes made (i.e. source change). The user must refresh the browser for the Dashboard to fully reflect current settings.

Discovery Tool Issues

• If PC being used to configure the CSPs has a dual NIC setup where user is on WiFi and using a Link Local direct connection, the Discovery Tool will be unable to identify the IP address of the CSP.

Browser Specific Issues

• While running the Quick Setup Wizard in Microsoft Edge, some options (Stereo, Phantom) may not show as available when configuring inputs. Advancing the Wizard past the current Input and then pressing Back will show the Stereo and Phantom selections.

• While using Internet Explorer, if a web browser has already connected to a PowerSpace+ when another attempt is made to connect to the same PowerSpace+, the user will be presented the “ Starting PowerSpace+ Configuration Utility” screen instead of "Multiple Browsers Connected" error screen.