New Updates for Bose Connectivity Products Released

New Features:

• Zoom Room certification
• VBT's can be added to Bose Work Management (BWM) through known IP
• RESTful API with basic authentication for control and management
• Implemented room compensation processing for reverberant rooms
• Microsoft Teams Telemetry is supported

Enhancements:

• BWM shows VB1 USB connection status
• BWM shows USB call status (HID supported clients)
• BWM shows USB audio streams and mute status for each
• BWM device list can be exported to .xls
• BWM allows mDNS discovery to be disabled

Fixed Bugs:

• VB1 does not connect to hidden networks
• Removed deprecated SSLv1.0, SSLv2.0, and SSLv3.0, TLSv1.0, TLSv1.1, and TLSv1.2 on wireless and wired network interfaces
• Eliminated vulnerabilities due to RC4/Arcfour cipher on wireless and wired network interfaces
• Eliminated vulnerabilities due to birthday attacks against TLS ciphers with 64-bit block (Sweet32) on wireless and wired network interfaces
• BWM retains sort order
• Improvements to default image settings: New default image settings will overwrite defaults from previous releases; settings changed by user will not be overwritten.

Open Issues:

• VBl's may take longer to be discovered in BWM after the initial start-up
• Online VBl's do not populate in BWM after being added manually. (Workaround: close and restart BWM)
• People counting only works when autoframing is enabled and camera stream is active.
• Person detection only works when autoframing is enabled and camera stream is active.
• If a mobile device, paired with VB1 for calls, ignores an incoming call, the VB1 audio level will be set to 50%.
• iOS users may not be able to connect via the Bose Work mobile app and Bluetooth at the same time. (Workaround: disconnect mobile from VB1 and use app to connect; if Phone BT was previously paired with VB1, user might see issues. User should forget VB1 from BT paired list and try again.)
• Exclusion zones set in Dynamic mode are still active in Static mode but not visible. (Workaround: disable all exclusion zones in Dynamic mode if using Static beams)
• The visual display of beams in BWC can be out of sync, especially on power up.
• Scheduled firmware updates in BWM do not work if NTP service is not set-up on VB1's. (Workaround: install updates manually)
• The VB1 comes out of standby if WiFi network is lost/comes back. (Workaround: disable Low Power Mode (LPM))
• On some older Dell laptops, the USB-C port may cause flickering when using DisplayLink. The workaround is to use a USB-A port.

Update Instructions:

Nothing known