PoE driver and Cisco Trusted Core Bundle update plus some fixes

Improvement(s)

✔ ️ Default IP Settings on Devices that Support OOB

In previous versions, the default management interface, on devices that support OOB in native mode, was applied to the OOB port and not on the default VLAN. In Hybrid mode default IP management interface is applied to VLAN 1 and OOB is disabled. From this version and on, the default management interface is applied to VLAN 1, even on devices in the native mode that support OOB. The OOB interface, in new behavior, will be DCHP enabled by default in native mode, and will not support the default IP settings. In Hyrid mode OOB will be disabled, as in previous version.

? Updated Cisco Trusted Core Bundle
The 3.1.1.7 firmware uses the Cisco core bundle

? New PoE Driver
New PoE driver version 0.2.0.17.

Resolved Issue(s)

✔ ️ Cannot access device privilege exec mode using enable password.

✔ ️ Device may reboot if connected Polycom phones send LLDP info.

✔ ️ Device may reboot if connected NEC DT800 phones send LLDP info.

✔ ️ Ongoing syslog messages related to FDB hash lision flood interfere with console usage.

✔ ️ Device GUI cannot load if any interface description includes the word "form".

✔ ️ Device will reboot if clicking on OLH general information sub items.

✔ ️ Fiber between SG350X-48MP and CBS350-48XT-4 flaps and then suspended

✔ ️ After awhile, the PoE will stop the power supply on some interfaces.

✔ ️ CBD Probe cannot connect if the name of the CA certificate configured on devices includes a space in the certificate name (for example "my cert").

✔ ️ Device reloads after setting IPv6 tunnel as route destination.

Known Issue(s)

? Certificate revocation configuration is missing from configuration file after
upgrading from an earlier version to version 3.1.1.7.

? CBD probe and mobile app fail to connect device with updated password after modify user password via device web gui.If modify user password via CLI or CBD probe, there is no problem.

Workaround: Log out the device web gui then log in with new password.

? CBS350-48P-4G: Port may power cycle when both wireless access point and phone are connected.

? CBS350-24P-4X: PoE not resetting properly and leading to PD devices losing power and flap).