Business 350 Series
How to enable Loopback Detection on the Cisco Business Series Switches?
How to enable Loopback Detection on the CBS Switches?
How to enable Loopback Detection on the CBS Switches?
loopback-detection enable (Interface)
To enable the Loopback Detection (LBD) feature on an interface, use the loopback-detection enable Interface (Ethernet, Port Channel) Configuration mode command.
Syntax
loopback-detection enable
Example
The following example enables the Loopback Detection feature on port gi1/0/4.
switchxxxxxx(config)# interface gi1/0/4
switchxxxxxx(config-if)# loopback-detection enable
You know a better answer?
The question about Cisco Business 350 Series has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
What is banner login command and how to use it in CBS 350 Switch?
<1Kviews
What is banner login command and how to utilize it?
How to display the logging status and SYSLOG messages in CBS3 350 Switch?
<1Kviews
How to display the logging status and SYSLOG messages in my switch?
How to set the idle session timeouts in CBS 350 Switch?
<1Kviews
How to configure the idle session timeouts ?
Was the content helpful to you?