New firmware features and network essentials
Improvements
- Support for the 30 ms MRP profile is added in this release
- REP configuration is enhanced to support an auto-discovery feature, which allows a REP node to learn the REP Segment-ID on the wire
Bug fixes
- QoS drops within IE3300 switch for Layer2 transit traffic below line rate
- VACL affecting traffic on non-specified vlans on IE3x00
- FHS IPv6 RAGUARD policy in IE3400 is not blocking RA traffic
- IE3400H-FE— Unable to configure MTU other than 1500 in 3400 FE switch with Network Essentials
- Autonegotiate to 10 Gbps instead of 1 Gbps with GLC-TE SFP
- CRC errors observed with IE3xxx with 10Mbps speed in Half-Duplex Mode
- EPC on IE3300 switches dropping packets of flows not allowed in the ACL filter
- Interface Gi2/1 in expansion module IEM-3400-8S not working in 17.X releases
- IE3300 16P expansion module granting POE to ports where power inline never was configured
- Interface vlan with unassigned IP address generating ICMPv6 Router Solicitation (IE-3300)
- When we have IOX/Cybervision enabled on the switch and attempt to soft reload it hangs
Open issues
- IOX: Observing Disk space issue for CCV app installation through sensor extension