for Cisco NCS 4206 and Cisco NCS 4216 Series

Improvements

• Framed SAToP System BERT

You can configure SATOP system BERT with framing under CEM circuits on T1 or E1 interfaces and verify if the BERT is stable and transmitted end-to-end.

• MFR End-to-End Mode

This feature enables transporting legacy MFR traffic over packet switching core.
You can now configure an end-to-end mode for frame relay pseudowire on the MFR interfaces for the following interface modules:
A900-IMA3G-IMSG
A900-IMA1Z8S-CXMS

• User-defined Remote Loopback on T1 Interfaces

You can customize the loopback codes on T1 in a 16-bit format in contrast to the standard 6-bit loop code on the 48-port T1 interface module.

• Out-of-order Packet Counter on the Cisco RSP3 Module

You can configure Out-of-order packet counter for FPGA-based SAT on the Cisco RSP3 module.

Bug fixes

CSCwf14167 - RSP3: uea_mgr memory leak on ARP probes
CSCwf27439 - IMD timer value update for ISSU process
CSCwf90667 - IMA8Z:frequent reloads of IM due to high temp- FAN speed mismatch
CSCwf42164 - No snmp trap link-status get re-added after IM reload
CSCwe82657 - VIN P2/0, VOUT P2/2, VIN P4/0 & VOUT P4/2 alarms upon SSO
CSCwf77276 - Memory leak seen on chunk module when BDI routed network traffic flow along with mac move
CSCwf49426 - PAIS alarm get reported after IM OIR.
CSCwf77316 - RSP3: MPLS incorrect label programmed with scenarios of double implicit-null
CSCwf69937 - The portchannel does not come up on adding recommended configs till we reload the router
CSCwf18367 - RSP3 : uea_mgr RIFID leak/comsumption for Muticast routes
CSCwf07736 - cem interface counters momentarily report error when x21 xconnect is cleared and re-established
CSCwh42209 - RSS memory increment continuously seen uea_mgr process upon system event
CSCwf54249 - With CPG, STS1e configuration is giving %ERROR: Standby doesn't support this command
CSCwf86864 - CEM traffic flow is dropped in one direction due to DEI bit set from 4202
CSCwf37941 - ACL config under serial interface makes dut crash during unconfig
CSCwh30217 - NCS4200-3GMS: With rate of OC12 we see "threshold sf-ber 3" getting added under sh run

Open problems

CSCwh85621 - Layer 2 CEF interface is unavailable.
CSCwh80239 - IP SLA multicast configuration is not working.