CiscoWebex Room Kit Pro
<1K views
How to connect the navigator to the codec?
I believe I am having a firmware issue with the Navigator. I can't get it to connect to the device to download the firmware.
CiscoWebex Room Kit Pro
Answers
Top answer
Connecting the navigator to the codec is done via an Ethernet cable and is usually very simple.
Here are the steps to connect the Navigator to a Cisco codec:
- make sure that the codec and the navigator are powered.
- connect the Navigator to the same network as the codec. This can be done either via Ethernet or WLAN.
Make sure that the codec and the navigator are on the same network segment. 4.
On the codec, go to the System menu and select Navigator. 5.
Check the Navigator option and enter the IP address of the Navigator. 6.
Click Apply to save the settings.
You know a better answer?
The question about Cisco Webex Room Kit Pro has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Related Questions
Room Kit flashes white. No connection?
I have several Room Kits in the administration and with one of them I can't get a connection between the Room Kit and Touch 10....
Stay up to date on Cisco Webex Room Kit Pro
Was the content helpful to you?
