The manufacturer Crestron has not yet set up its devicebase profile. Content such as updates, compatibilities and support may only be maintained with a delay.
Update

Resolved an issue where the router would not configure itself

Resolved bugs:

  • Resolved an issue where the router would not configure itself properly if it didn’t get an IP address within 10 tries. This only applies to units with a Rev3 router board.

Additional Notes:

  • From firmware 2.8003.00020 and up, the following has changed:
    Before upgrading a router-based control system to 2.8003.00020, make sure to upgrade it to 2.8001.00098 first. Upgrading to 2.8003.00020 directly could result in the router firmware upgrade failing.
  • Any control system that ships with a Rev3 router board must run firmware version 2.8003.00020 or greater and cannot be downgraded to a firmware version below 2.8003.00020.
  • Any control system with a Rev2 router board can still be downgraded to a firmware below 2.8003.00020
Version: 2.8003.00057.01I Link
Receive Important Update Messages Stay tuned for upcoming Crestron CP4N updates

More from the Media Control section

Was the content helpful to you?

Advertisement Advertise here?
Udemy IT certification ad