Added IPV6, Ability To Configure SNMP Via The Web User Interface, Fixes

Improvements

NEW FEATURES

• Added IPV6, all limitations and known behavior for IPV6 are listed below. Please note that IPV6 is disabled by default.
  • Support for IPV6 is only for dual enabled networks with both IPV4 and IPV6 and not supported in IPV6 only networks.
  • A reboot is required whenever IPV6 is enabled or disabled.
  • The following functional features are not supported with IPV6 only, if you have a dual enabled network with IPV4 and IPV6, they will continue work through IPV4.
    • Video streaming
    • SIP
    • SNMP
    • IPV6 over Wi-Fi
    • 3rd Party Scheduling apps
    • XiO over IPv6
    • Fusion
    • Proxy server
  • DHCPv6 is not supported (only SLAAC and Static IP addresses are supported)
  • Restore command disables IPV6, therefore if you initiated the restore command remotely on an IPV6 only network, you will need to go to the touch screen's setup menu to enable IPV6 again.
  • IPv6config' and 'IPv6config /all' command output is blank for IPv6 DHCP address since DHCP is currently not supported. Also note that IPconfig or IPconfig /all command will not show and IPV6 information. To view IPv6 information please use IPv6config commands.
  • Assigned SLAAC addresses are not EUI 64 based addresses.
  • When using multicast filtering if you have a device in the network that produces high bit rate multicast streams (like an NVX), the ethernet switch must be configured carefully to make sure the high-bitrate streams are only passing through the ports that are required. Configuration capabilities differ between different brands and models of switches, ideally you would want to pass IPv6 multicast but block the addresses of the streams where appropriate
  • When in static IPv6 configuration there is no to add a domain name statically, therefore FQDN needs to be used and the DNS server will need to have static IPv6 address to FQDN mapping.
  • AD login can take over a minute when there is an invalid IPV6 static DNS entry.
  • The default router must be configured in the text console using the "ipv6defrouter" command.
  • The "ipv6defrouter" command does not prompt the user to reboot after adding a default router, a reboot is required after adding the router.
  • The webui status page shows the RDNSS server address labeled as DHCP instead of SLAAC/RDNSS.

• Added the ability to configure SNMP via the Web User Interface.

• MS Teams Panel
  • Corrected issue with DUT not asking for language ion after a factory reset.
  • Corrected issue with back light brightness configuration pushed from DN was not reflecting on the DUT.
  • Corrected issue with the panel showing "Error running UI" after the CP component was upgrade from TAC.

Important notes

ADDITIONAL NOTE

• Version 2.001.0058 upgrades the Touch Screens OS to Android 10, if you upgrade to
  this version you will not be able to downgrade to a lower version firmware.
• Firmware 2.001.058 has been approved by Microsoft's Android 10 Certification
  program and is supported for use with Microsoft Teams Panel.
• Please note when using Static IP Configuration, a pingable Gateway address must be
  specified.