Reset to factory settings?

Hello. There are some steps to do. Let me explain.

Step 1: Create a bootable firmware reset USB

1. Start off by downloading the Firmware Reset file from the Evoko Liso download page.

2. Download Etcher, install and then run it on your PC.

3. In Etcher press Flash from file.

4. Select the downloaded firmware reset image and press Open.

5. Insert and select your target USB flash drive.

6. Caution: All existing data on the USB flash drive will be deleted. To proceed, press Flash!

The process usually takes around 5-10 minutes depending on the write speed of the USB flash drive.

When Etcher is finished writing the reset image to the USB flash it will do a check to verify.

Once the image has been verified it will be ready to use.

The USB drive name should now be Boot imx6dl and should contain some new files.

Please note that there are partitions not normally visible by Windows and you might get error messages saying you need to format the drive before it can be used. Please ignore these messages.

Step 2: Boot Evoko Liso with the firmware reset USB

Next step is to boot the Liso from the newly created firmware reset USB rather than the internal storage.

1. Power off the Liso by removing the PoE or power cable.
2. Insert the firmware reset USB into the Liso USB port.
3. Power on the Evoko Liso by inserting the PoE or power cable and wait.
4. If successfully booted from the USB stick the following text should be displayed:
5. Once the firmware reset is complete the following text should be displayed:
6. Remove the USB flash drive and reboot the Liso.

I hope that helps.