Firmware update 2.6.1 to 3.0.3 fails?

Hello everyone,

I have an eBox professional which I just wanted to update from 2.6.1 to 3.0.3 via web interface... But it fails - without an error message... I can log in very briefly on the web interface and see that 3.0.3 is installed, then the connection breaks off and the box rolls back to 2.6.1 on its own and after 3 minutes I can log in again and the firmware is back to 2.6.1 ...

Does anyone have a similar problem or any idea what the problem could be?

Regards

Answers

You know the answer?

Unfortunately, there is no answer to this question yet. Answer it now and increase your reputation as an industry expert in our B2B community.

To the product All questions

Related Questions

Where is the SIM card installed?

<1Kviews Bugs; Features; Setup;

My ebox is "dead" (except for the meter display on the side) and I suspect a problem with the SIM card. I wanted to check...

4 Read answers

Where is the SIM card installed?

<1Kviews Bugs; Compatibility; Features; Installation; Setup;

According to the manual, any SIM card (anySIM) can be used here. The manual shows the card slot by the white connection cable - but...

Go to question

innogy eBox professional firmware update and LAN connection?

<1Kviews Bugs; Compatibility; Features; Installation; Setup; Technology; Update;

@jochen-bremen
I also thought that version 2.2.0 would be the first firmware I would have to install and then the others.
Regarding the LAN problem: Everything is...

Go to question

Was the content helpful to you?

Remarks

Advertisement Advertise here?