PROFIBUS
What is PROFIBUS termination?
What is a PROFIBUS termination and how can be implemented in order to create a power-safe network?
What is a PROFIBUS termination and how can be implemented in order to create a power-safe network?
To have a good signal transmission in one PROFIBUS network, it is necessary to terminate segments of it by a bus.
There is a slight difference when it comes down to PROFIBUS RS-485 termination with a combination of three resistors and PROFIBUS MBP (PA) bus termination with one resistor and a capacitor.
The PROFIBUS terminations that are built into PROFIBUS devices or PROFIBUS connectors can be switched on or off. It can easily happen that there are too many bus terminations used in a PROFIBUS segment. This situation must be observed to make sure that only the ends of one PROFIBUS segment are terminated, and nowhere else in that place.
You know a better answer?
The question about PI PROFIBUS has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
What is the difference between PROFIBUS and PROFINET?
7.4Kviews
What makes PROFIBUS and PROFINET stand from one another, and how can I decide which one should I use in my application?
Why and where is fiber-optic transmission used?
1.3Kviews
Why and where is fiber-optic transmission used?
what is the maximum distance on communication works?
5.6Kviews
what is the maximum distance on communication works?
Was the content helpful to you?