Designer workflow enhancements

Improvements

• Designer workflow enhancements

Bug fixes

• ID-10248: SDC for P300 accepts invalid DNS IP addresses
• ID-10236: Default Deployment fails with MXA-920-S device(FW 6.5.70.0)
• ID-10205: Analytics-Incorrect values are displayed in device_online event
• ID-10159: AEC Reference should be set to "Dante Output 1" if the output is routed to a MXN-6 device.
• ID-10157: Incorrect values are displayed in device_discovered event
• ID-10126: Online devices property panel mute button has wrong tooltip
• ID-10123: Online devices are not detected when selecting correct NIC on the first launch after installation
• ID-10109: Bypass Intellimix dialog is displayed instead of Bypass DSP dialog when enabling DSP from limiter
• ID-10102: Unable to copy dante channel name in new design
• ID-10101: MXN5-C's Dante output is labeled as "Spkr out" (routing view)
• ID-10097: Y values under position section are not retained after device reboot.
• ID-10095: Failed to Add Device Message occurs when attempting to add the same device to a room
• ID-10094: Devices are not sorted alphabetically in layers side panel in coverage view
• ID-10091: All live devices should display immediately when association is cleared in the deployment
• ID-10083: Limiter engaged indication is displayed when Limiter is Off
• ID-10064: MXWN TX devices not being shown in online devices table
• ID-10056: Default settings failing for virtual MXA310 device and deployment failing
• ID-10003: Designer slow to load room view with medium-large MXWN room
• ID-9994: Incorrect message is displayed when uploading empty certificate in 802.1X tab
• ID-9984: Deployment failure of IMX-Room or P300 with FW version 6.4.x
• ID-9886: Action of "Go Online without Changes" is very slow
• ID-9551: Unable to launch SDC for both online and virtual MXN6 devices
• ID-9406: Encryption key symbol is missing for 2nd channel strip of MXN6P after preforming reboot.
• ID-9385: Active preset indication is missing for MXN5-C V3, MXN-6-P V3 devices after a reboot
• ID-8485: Incorrect model name change for MXN-6
• ID-8221: AEC Ref route is in red color even after performing rekey audio encryption
• ID-9590: MXN5-C may reboot when the speaker output gain is increased to a level that causes excessive power draw on the switch.