SiemensFail-safe module SM326F
1.1K views
Why does error occur when leaving the I / O setup window?
Why does error 2988: 2074 occur when leaving the I / O setup window?
SiemensFail-safe module SM326F
Answers
Top answer
2988: 2074 indicates the properties of an object. The IO address must not exceed the maximum image of the processor. Your address probably exceeds the allowed image of the processor.
Follow these troubleshooting steps:
- Close the IO Address Setting window.
- Switch mode without module protection
- Change the F destination address of the other fault protection module
You know a better answer?
The question about Siemens has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Related Questions
Why does open circuit recognition take longer than other modules?
Why does open circuit recognition take longer than other modules?
Can this module be combined with the S7-300 series security PLC?
Can this module be combined with the S7-300 series security controllers?
Stay up to date on Siemens
Was the content helpful to you?
