SiemensSM 374
<1K views
The module has stopped and is requesting a memory reset?
The module has stopped and is requesting a memory reset?
SiemensSM 374
Answers
Top answer
This happens when a project contains some invalid blocks or operands for the CPU. Then the CPU stops and asks for a memory reset.
To solve this problem you need to switch the CPU to STOP mode. Pull out the memory card and confirm the memory reset request. Replace the memory card and your system can continue operating.
You know a better answer?
The question about Siemens SM 374 has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Related Questions
How is Profibus DP data read using SFC13 "DPNPM_DG"?
How is Profibus DP data read using SFC13 "DPNPM_DG"?
What is the CPU Emergency Address and when is it used?
What is the CPU Emergency Address and when is it enabled / disabled?
Why should a memory card never be removed while system works?
Why should a memory card never be removed while the system is in operating mode?
Stay up to date on Siemens SM 374
Was the content helpful to you?
