Access Point AC ProUbiquiti
Access Point AC Pro
<1K views

Ubiquiti Ubiquiti Access Point AC Pro does not accept adoption through the controller?

Good day,I have an Ubiquiti Access Point AC Pro which when I try to adopt using the controller it doesn't accept. After some research I discovered an application that I could use to adopt the Ubiquiti Access Point AC Pro which worked very well. Could there be a problem related to the controller? I ask for your assistance

Answers

Hi,

There are several causes for this problem.

  • You can reset the AP by pressing the reset button, e.g. with a paper clip for about 5 seconds. If you only press it briefly, it will restart.
  • The firmware on the AP is too old, then the controller cannot integrate the AP correctly.
  • The AP cannot resolve the address Unify:8080/inform via DNS. To do this, set a DNS record or connect to the AP via SSH and type Set-Inform http://Your_Controller_IP:8080/inform
  • It is important to always keep the Unify firmware up to date.

You know a better answer?

The question about Ubiquiti Access Point AC Pro has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.

Related Questions Related Questions

Receive Important Update Messages Stay up to date on Ubiquiti Access Point AC Pro

Was the content helpful to you?

Advertisement Advertise here?
Udemy IT certification ad