Controller PFC100Wago
Controller PFC100
1.5K views

invalid result package?

Hi there, when trying to connect to the controller I am getting the following message: "

invalid result package"

Appreciate any help please, I am using e!Cockpit NOT Codesys.

Thanks!

Answers

Top answer

I know this is old, but I thought I would reply for anyone else's sake.

I'm assuming you uploaded an IPK file to run on the WAGO. I had the same thing, and no matter what I did, upgrade FW, downgrade FW, it would not go away.

Since I was changing the FW from e!Cockpit, it wasn't until I loaded the FW via SD card, that it finally went away.

WAGO has a github for FW releases. They also have instructions to load it.

I found that if you:

  1. Loaded the FW via SD card as per instructions
  2. Created boot image via web interface
  3. Power down PFC
  4. Remove SD card and set Run switch to Stop
  5. Power up again
  6. Upload desired ipk
  7. REBOOT again

Then it should work for you.

Good luck.

abtimj
abtimj / newcomer (17)
 

You know a better answer?

The question about Wago Controller PFC100 has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.

Related Questions Related Questions

Receive Important Update Messages Stay up to date on Wago Controller PFC100

Was the content helpful to you?

Advertisement Advertise here?
Udemy IT certification ad