Dante Models Update: New Features and Resolved Bugs

New Features:

• You can now route analog signals to DZR-D and DXS-XLF-D for output to a Dante network.
• Dante firmware must be updated to 4.1.6.7-4.1.6.5-1.1.0.

Enhancements:

• Improved operation when disconnecting while transmitting information to an external control device, such as ProVisionaire Control or ProVisionaire Touch.

Fixed Bugs:

• Solved a problem in which the operation of the main knob to remove the panel lock was reflected immediately after the lock was removed when the PIN code had been saved to a USB flash drive.
• Solved a problem where some current parameters could not be loaded when restoring data, including AMP PRESET in DEVICE BACKUP > RESTORE FROM USB (V1.1.1 or later).
• Solved an issue where the Dante settings seemed to change when loading a setting file from a USB flash drive while DANTE SETUP was set to lock or DDM (Dante Domain Manager) was set to READ ONLY.
• Solved an issue where the Dante Rx label was not set to the default value when connecting mode to the Dante network was read from Quick Config to STANDARD mode.
• Solved a problem where the mixer (CL/QL series) did not notify that the maximum number of connectable external control devices had been reached.
• Solved a problem where the display was not updated after updating the IP address when set to DHCP.
• Resolved several issues when using ProVisionaire Control:
• The OVER indicator in Analog > Meter would not light.
• Dante Input Meter displayed about 1dB lower than the actual value.
• Resolved issues when using ProVisionaire Touch:
• Exclusive settings of (A1, A2, D1, D2) and POST EQ on the ROUTER screen.
• Some EQ Gain values.
• Time value of ALIGNMENT on the ROUTER screen.
• HPF/LPF frequency value on the HOME screen.
• Fixed several minor errors.

Open Issues:

• When mounted on the CL/QL series, the version number may not be displayed correctly on the I/O DEVICE screen.
• When the delay time is set to DISTANCE [m, ft], the displayed value may change when the power is turned off and on due to a conversion error with TIME [ms].

Update Instructions:

Nothing known.