Brings Zoom Room Certification Along With New BWM-related Features

Improvements

• Zoom Room certification

• VBT's can be added to Bose Work Management (BWM) through known IP

• RESTful API with basic authentication for control and management

• Implemented room compensation processing for reverberant rooms

• Microsoft Teams Telemetry is supported

• BWM shows VB1 USB connection status

• BWM shows USB call status (HID supported clients)

• BWM shows USB Audio streams and mute status for each

• BWM device list can be exported to .xls

• BWM allows mDNS discovery to be disabled

Bug fixes

• VB1 does not connect to hidden networks

• Removed deprecated SSLv1.0, SSLv2.0, and SSL3.0, TLSv1.0, TLSv1.1, and TLSv1.2 on wireless and wired network interfaces
• Eliminated vulnerabilities due to RC4/Arcfour cipher on wireless and wired network interfaces
• Eliminated vulnerabilities due to birthday attacks against TLS ciphers with 64-bit block (Sweet32) on wireless and wired network interfaces

• BWM retains sort order

• Improvements to default image settings

New default image settings will overwrite defaults from the previous releases, settings changed by user will not be overwritten.

Open issues

• VBl's may take longer to be discovered in BWM after initial start-up

• Online VBl's do not populate in BWM after being added manually. (Workaround: close and restart BWM)
• People counting only works when autoframing is enabled and camera stream is active.

• Person detection only works when autoframing is enabled and camera stream is active.

• If a mobile device, paired with VB1 for calls, ignores an incoming call, the VB1 audio level will be set to 50%.
• iOS users may not be able to connect via the Bose Work mobile app and Bluetooth at the same time(Workaround: disconnect mobile from VB1 and use app to connect). If Phone BT was previously paired with VB1, user might see the issues. User should forget the VB1 from BT paired list and try again.

• Exclusion zones set in Dynamic mode are still active in Static mode but not visible. (Workaround: disable all exclusion zones in Dynamic mode if using Static beams)
• The visual display of beams in BWC can be out of sync, especially on power up.

• Scheduled firmware updates in BWM do not work if NTP service is not set-up on VB1's. (Workaround: install updates manually)
• The VB1 comes out of standby if WiFi network is lost/comes back. (Workaround: disable Low Power Mode (LPM))
• On some older Dell laptops, the USB-C port may cause flickering when using DisplayLink. The workaround is to use a USB-A port.