Improves Auto-Framing, Output Resolution, Mic Beam Tracking, and More

Improvement(s)

? Multiuser installation support for Bose Work Configuration, BWC installation is now accessible to all users who log in to the system on which it is installed.

✔ ️Auto framing speed improvements

✔ ️Microphone beams now track talker more accurately.

✔ ️VB1 now outputs 1280x720 resolution for Barco CX with Barco firmware v2.08.

? New default image settings.

• New default image settings will overwrite defaults from the previous release. But settings changed by the user will not be overwritten.

Resolved Issue(s)

✔ ️50Hz antiflicker setting is fixed and is a persistent setting

✔ ️Detect and inform user of lack of write access to USB during VB1 firmware updates.

✔ ️Green LED robustness when camera is streaming.

✔ ️Corrections to owner's guide error describing GPI.

✔ ️SNMP API handles the 0 sub-identifier for OID values.

✔ ️SNMP API get/set operations are still usable when trap server is unavailable, or not set.

✔ ️Using Bose Work Configuration and Bose Work Management at the same time to adjust microphones may cause a conflict.

✔ ️Camera disabled setting retained through reboot.

✔ ️Bose Work Configuration App UI fixes:

• Bluetooth metering previously showed even when there were no devices were connected.

• Bluetooth shows streaming when device was connected, even if there was no signal.

• USB output level metering now appears.

• Changed GPI to CTRL to match label on hardware.

• Pacific standard time is appropriately GMT-8.

Known Issue(s)

? If a mobile device, paired with VB1 for calls, ignores an incoming call, the VB1 audio level will be set to 50%.

? iOS users may not be able to connect via the Bose Work mobile app and Bluetooth at the same time.

Workaround: disconnect mobile from VB1 and use app to connect.

If Phone BT was previously paired with VB1, user might see the issues. User should forget the VB1 from BT paired list and try again.

? Exclusion zones set in Dynamic mode are still active in Static mode but not visible.

Workaround: disable all exclusion zones in Dynamic mode if using Static beams.

? The visual display of beams in Bose Work Configuration can be out of sync, especially on power up.

? Some users may experience an overly dark image after loading a profile. PressRestore Image Settings to fix the image.

? Scheduled firmware updates in Bose Work Management do not work if NTP service is note set-up on VB1's.

Workaround: install updated manually.

? The VB1 comes out of standby if WiFi network is lost/comes back.

Workaround: disable LPM

? On some older Dell laptops, the USB-C port may cause flickering when using DisplayLink. The workaround is to use a USB-A port.