Resolved issue with large CWS requests

New:

• Updated AVF to version 6.29

Resolved bugs:

• Resolved issue with large CWS requests sometimes leading to an exception.
• Resolved issue where it could take a long time for an IPv6 address to be allocated if there was already an IPv4 address allocated.
• Resolved issue where programmatically getting the MAC address would result in returning an incorrect MAC address.
• Resolved issue where broadcast data would be received twice on a router-based control system.
• UDP communication symbol in SIMPL would not receive any data when IPv6 is enabled.
• Resolved an issue where LAN IP address would be inaccessible when a USB to Ethernet adapter was being used.
• Resolved an issue that could result in CH5 WebUI token validation to fail.

Additional Notes:

From firmware 2.8001.00041 and up, the following has changed:

• This firmware enabled IPv6 support for the 4-Series Control Systems. IPv4 networking is still supported with this release.
• IPv6 can be configured from the command line, as well as through the WebUI.
• To use any IPv6 socket communication from SIMPL+ or SIMPL#, your program needs to be compiled with an updated database:
• Device Database 200.245.001.00
• Crestron Database 216.05.002.00
• Include4.dat 2.19.036
• Please see the IP Guidelines for the IT Professional document (Doc. 4579N) and OLH Article 1001836 for additional information on IPv6 networking.
• SNMP cannot be enabled/disabled anymore through ENABLEFEATURE but should be enabled/disabled with SNMP ON/OFF console command.
• When downgrading from 2.8001. firmware to 2.7000. firmware, any SNMP settings that were made while on 2.8001.* firmware will be removed.