Crestron4-Series™ Control Engine
<1K views
CP3 Slaved to a CP4 – is it possible?
Is it possible to set up a Crestron CP3 as a slave to a CP4?
Crestron4-Series™ Control Engine
Answers
Top answer
This setup can be possible of course, is the same as slaving a series 2 to a series 3 or 4.
There is an al way to do it as well - putting the IR drivers in a SIMPL program on the CP3 and EISC those signals over to the main CP4 controller.
You know a better answer?
The question about Crestron 4-Series™ Control Engine has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.
Related Questions
What does Crestron ID mean?
What exactly does the Crestron ID mean on various devices such as touch panels and controllers?
What is the best way to control a Samsung QM display?
Are there drivers for Samsung displays or what is the best way to drive a Samsung display (QM series)?
CP4N Control Subnet not handing out DHCP addresses?
Does DHCP reservation need to be done on devices connected to a switch, plugged into the Control subnet of a CP4N?
Stay up to date on Crestron 4-Series™ Control Engine
Was the content helpful to you?
