Error after update?

Hello I have a master slave configuration and have run an update of the software. Actually the slave should update itself automatically. Instead it lights red and is out of service. By ping also no longer reachable. Powerless set has also brought no result.

Can someone tell me what it could be or how to restart them.

Many thanks

.

Answers

Top answer

LED bar flashes red

Fault

Faults must always be acknowledged by disconnecting the charging cable.

Switch off the supply voltage to the charging station (built-in or upstream RCD and circuit breaker).
Disconnect the charging cable from the vehicle and the charging station. Switch the supply voltage back on.

The charging station is defective - Contact your service partner.

You know a better answer?

The question about KEBA KeContact P30 has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.

To the product All questions