PX30x problems after SW updates known?

STATUS: After commissioning 09/2022, the updates from v1.13-v1.15 were installed one after the other via USB.
Update v16.1 ran through to step 9 of 13. Then the installation hung for more than 60 minutes and the LED flashed green/red. The process was then repeated.
After completion, access to the Web UI via LAN/ WLAN was only possible again after changing the CFG file. (Support request)
Update v17.1 (USB) hung again at step 9, and again only ran through after repeating the process. This time the Web UI could only be reached via the HOTSPOT (IP outside the Home-NW). (see Config-Manual/ 2.1.3-WLAN Access Point (Hotspot)
Updates v17.2 and v18.1 (USB) were installed, but not displayed as release version 17.2 or 18.1.
QUESTION: have similar problems been reported in the group after updates, and are there any known solutions (apart from factory resets)?
/juk

Answers

You know the answer?

Unfortunately, there is no answer to this question yet. Answer it now and increase your reputation as an industry expert in our B2B community.

To the product All questions

Related Questions

Does anyone have the KEBA Service Tool?

<1Kviews Setup Technology

Hi!
Does anyone have access to the official KEBA Service Tool for configuring KeContact P30 chargers? I need it to enable OCPP and adjust settings via...

1 Read answer

Why do our RFID cards keep going back to Invalid status?

<1Kviews Bugs Features

We operate a charging network consisting of one P30 x-Series (master) and five P30 c-Series (slave) wallboxes. This has worked perfectly for a good year...

Go to question

Keba P30x updates do not work. Does anyone know what to do?

<1Kviews Bugs Update

Hi has anyone had problems updating the Keba P30x via USB or web ?

It is currently stuck at 1.13.
Updates to 1.14.1 did not work and...

Go to question