RFID cards cannot be read

Deposit RFID Mastercard / relearn.

By default, a charging process can be started without authorization.In order to be able to use authorization via RFID, RFID cards must bemust be programmed.A maximum of 20 RFID cards can be programmed at a charging station.First, an RFID master card must be programmed. This can be used tofurther RFID client cards can be programmed.To teach-in the RFID master card and to delete the taught-in RFID cards, a restart is required.RFID cards, the charging station must be restarted via the service button.

• To access the service button, the device must be opened.
  
  
  
• The service button 1 in the connection panel is now accessible.
• Press and hold the "service button" in the connection panel until the second signal tone sounds (approx. 10 seconds).
• The charging station now restarts automatically.
• Immediately after the charging station restarts, an RFID master card must be taught-in within 60 seconds by holding it in front of the RFID reader.
• A successful teach-in is confirmed with a signal tone.

Teach-in RFID card

• To teach-in the RFID client card, proceed as follows:
• Hold the RFID master card in front of the RFID reader until a signal tone sounds.
• Hold the RFID client card to be taught in in front of the RFID reader within 3 seconds. A successful teach-in is confirmed by an increasing tone sequence.
• Confirm the teach-in process within 3 seconds by holding the RFID master card in front of it again. The process is confirmed
  completed by a further rising tone sequence.

For further functions, please refer to the manufacturer's operating instructions