KeContact P30KEBA
KeContact P30
1.7K views

Welche DIP-Schalter Stellungen werden benötigt um die eine Ausgangsladestärke von 16A zu erreichen?

Moin in die Runde, gestern wurde meine Wallbox montiert. Abgesichert mit 16A.Gerade einmal nach den DIP Schaltern in der Box geschaut, da sind wohl 25 A eingestellt.Ist doch eigentlich zu viel, oder?

rainer
rainer / enthusiast (176)
 

Answers

Top answer

With a maximum charging power of 25A and a fuse protection of 16A, the fuses of the electrical installation may switch off depending on the vehicle type. There are several variables for the choice of fuse, such as cable length, cross-section, etc.

However, you should consult your responsible installer.

Information

Changes to the DIP-Switch settings will only take effect after aafter a restart of the charging station!For a restart, press the "service button" until the first signal tone is heard(approx. 1 second) or switch off the charging station briefly via the circuit breaker.

Caution: Damage to persons and objects cannot be ruled out if the safety instructions from KEBA are not observed.

The settings of the DIP switches should be set as shown in the screenshot.

KETA P30 Dip switch.jpg

highmo
highmo / expert (1815)
 

You know a better answer?

The question about KEBA KeContact P30 has already been answered, but there may be a better solution or alternative available by now. If you know it, answer the question now and increase your reputation as an industry expert in our B2B community.

Related Questions Related Questions

Receive Important Update Messages Stay up to date on KEBA KeContact P30

Was the content helpful to you?

Advertisement Advertise here?
Udemy IT certification ad